Results 1 to 8 of 8
Thread: Prints coming out 'shifted'
Threaded View
-
07-24-2014, 04:43 AM #4
- Join Date
- Jul 2014
- Posts
- 14
Yes, Roxy, the build plate is the standard three screw spring-mounted type.
Thanks jfkansas...I will give that a try. Would you perchance remember how long you cut the tube pieces to put into the springs?
I contacted flashforge support and they told me it could be a loose belt. I tightened the belt and that had no effect...I still get the same results. The results are a bit different though depending on when I print them out during the day. If it is late afternoon/early evening, they look like the pics attached. If I wait until 9pm at night, they look a bit better...not as shifted/offset.
Any other ideas? Are there other types of build plates other than the standard 3 screw spring mounted for the Creator X?
I appreciate all the help!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help