Results 1 to 4 of 4
Thread: Another Slic3r question
Threaded View
-
07-20-2014, 03:00 PM #3
I had one design from Thingiverse that I rotated in NetFabb Basic so that Slic3r would slice it in the orientation the way I wanted it. That design was chock full of errors too, but using Netfabb to only fix the errors still left the part oriented the way it was.
You're still likely using Slic3r 0.9.9. Nothing necessarily wrong with that but I'll mention that Slic3r 1.1.6 appeared to hang (left alone for over an hour) on the design once I rotated it. Version 0.9.9 got through it OK, but it did take a while.
When I ran into the orientation issue, I looked at Meshmixer to see if I could rotate it with that, but wasn't sure.Last edited by printbus; 07-20-2014 at 03:02 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion