Results 1 to 10 of 57
Threaded View
-
07-19-2014, 03:13 PM #11
Basically, you change your Marlin firmware to have auto bed leveling turned on. The only other thing you do is get a cheap servo off of eBay to kick down a leg with the Z-Limit switch on it.
If you can run a Wade's extruder on your machine, check out: http://3dprintboard.com/showthread.p...light=Wade%27s
You will see where the probe goes and how the servo mounts into the extruder.
You would just order a servo such as this to fit into the extruder and then print up the parts:
http://www.ebay.com/itm/1PCS-x-SG90-...item4623c4e449
And if you run the Enhanced G29 Auto Bed Leveling command found here:
http://3dprintboard.com/showthread.p...ed-G29-command
You will get lots of help getting it going!Last edited by Roxy; 07-19-2014 at 03:19 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help