View Poll Results: What's your preferred Heatbed Surface?
- Voters
- 12. You may not vote on this poll
-
Kapton Tape, single / double sided
1 8.33% -
Blue painters Tape
6 50.00% -
Glass
1 8.33% -
Aluminum Bare
0 0% -
Glass with ABS slurry/ hairspray
3 25.00% -
Aluminum with kapton ABS slurry/ hairspray
1 8.33%
Results 1 to 10 of 16
Thread: Blue Tape vs Kapton
Threaded View
-
07-18-2014, 01:05 AM #2
I think the Poll would generate better data if you separate "slurry" and "hairspray" as they are really not similar adhesives. Slurry is a thin (yet bumpy) layer of ABS and Hairspray is a thin (perfectly smooth) layer of vinyl. I'd also add "Purple Elmers Glue" to the Poll. Also, the Poll should probably be filament specific. If I'm printing ABS or PET+ I'd answer it completely differently than if I were printing Nylon.
Bambu P1S/AMS
NVision4D http://nvision4d.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion