Results 1 to 10 of 31
Thread: Printing with Nylon
Threaded View
-
07-15-2014, 08:51 PM #28
Final wrap-up. Today I printed one of the cleanest parts I've ever printed. It was with Bridge Nylon. I didn't use particularly thin layers or a slow print speed (.24mm and 40mm/s). Granted, I've spent months calibrating this machine and I do expect good prints (as long as I can get them to stick and not warp), but, I am thoroughly impressed with Bridge.
Here is a shot of the part. The hole is a 1/4" hole for a 1/4-20 bolt and is really, really clean. I'll pass a bit through it to clean it up but I really don't need to. The flutes (grip) at the left printed nicely too. I got zero warp on the contact surface with a 6 line brim. I mean zero. It's glass flat. So anyway, just wanted to pass this along.
_Bridge.jpgBambu P1S/AMS
NVision4D http://nvision4d.com
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help