Results 1 to 10 of 31
Thread: Printing with Nylon
Threaded View
-
07-12-2014, 10:43 PM #27
I have great news to report. I've now made two prints with Bridge Nylon and it is amazing stuff. I took years off of my life trying to print 618 Nylon. Bridge prints on glass with Elmers glue stick and it sticks like crazy. In fact, I had some filament stream out of the hotend at 'Home' and it coiled up on the bed (untreated area over in that corner) and it stuck to the bare glass. How nice is that?
The only problem I had was on a small layer that printed in too short of a time several spots tended to melt and get ugly. I need to change the 'minimum time per layer' parameter from 5-seconds to something longer and test again. But, I think that will solve it.
So, to come full circle in this long thread, Idabkey, get some Bridge and try it. Thanks to Jim for recommending it.Bambu P1S/AMS
NVision4D http://nvision4d.com
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help