Auto_Bed_Leveling: Z-Probe Repeatability code

[brainscan]

No Problem!!!



It looks from the printout later that everything is good... But if you attach your current Merlin_Main.cpp I'll do a quick DIFF and make sure that #endif was safe to take out.



Adding a 't' or 'T' to the G29 is helpful because you can see how flat the bed is from the Bed Height Topology map. Ideally, you should have a '0' after each decimal point. Like +0.0xxx or -0.0xxx The last line isn't supposed to be positive. I bet you are thinking about previous discussions where people's Z-Axis was going the wrong direction. The DIAGONAL of the matrix should be POSITIVE!!!!!

Yes now you've said it you're right I am thinking about the delta being positive (my maths is bad anyway so I get confused easily), I will add in a T to the G29. I am still having problems with it though, tried a print and the nozzle still just air prints. The z axis move to show its using the bed level matrix but because its so far from the bed I cant tell if its following it properly. Sorry I know this is the wrong thread for this problem so I will make a new post there with any files you want? Thank you, feel so close now!!!

Those are super good numbers!!! Trike is the only one with better numbers so far. You might want to use the 'L' parameter to stress the X & Y axis a little also and see if there is much additional extra slop there. Like M48 L 7 but my guess is your machine is very tight and crisp! I wish mine could do those numbers!

Thanks I was surprised how good they were actually and I know there is play in the probe as its only a thrown together prototype(cant print my new one until I sort out the bed levelling)