Results 1 to 10 of 16
Thread: Makerfarm & Z motor coupling
Threaded View
-
06-22-2014, 05:28 PM #12
Incidentally... Those are from the Prusa i3 open source. I had a problem where my clamps kept cracking and falling off. So I scaled the clamp to different sizes so I could try different ones and see which ones held and did not break. They clamp down with a M3 cap screw. One of those will probably grab the vinyl just right. Hopefully... They will fit within the tolerances you have.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help