Okay, so I've now figured out after reading the online manual (Which appears to be slightly different than the printed copy I had, and has links to different drivers) that if it isn't connecting, you can hit the Reset button if it doesn't connect, and for some reason, every time I plug my printer in, I have to press reset twice, but then it connects perfectly. Anyway, I covered the bed in Kapton tape and glue/water mixture, turned on the fan, and heated up the hotend to 220 degrees, and a few blobs of the test filament that was still in there came out. (Yay! Progress!) However, now when I tell it to extrude 50mm, and then hit extrude. The extruder gear (I think that's what it's called - the gear that pulls the filament through to the hotend) starts moving, but it turns a tiny amount, and then clicks back to where it was before, so it basically isn't turning anywhere. The manual said to try tightening or loosening the "Countersunk gear" - Not sure if that's a stardard term or not, but it's a gear on the top of the extruder that is supposed to make more or less of a gap for the filament to go through, but it doesn't change anything.