Results 1 to 3 of 3
Thread: FlashForge CreatorX
-
06-15-2014, 06:15 AM #1
- Join Date
- Jun 2014
- Posts
- 2
FlashForge CreatorX
For what it is worth those who are on the Fence I think the FlashForge is good value, gives good prints in general. I did move to simplify3D as a slicer and my only complaint is that USB support is unstable. I think it is the Printer not the software. so SDCard printing is the only way to go.
-
06-16-2014, 08:28 PM #2
How long you had one? I am expecting a X tomorrow, so I am not sure about the different videos and threads on which firmware and software to d/l and use.
-
06-17-2014, 06:12 AM #3
- Join Date
- Jun 2014
- Posts
- 2
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help