Results 1 to 4 of 4
Thread: The power of Acetone
-
06-14-2014, 12:39 PM #1
The power of Acetone
Hey guys,
I would like to open a topic here where we can share our experiences with Acetone and your prints,
As its a fun method that cleans your prints marvelously,
So far i have done it a few times, Always at 110c on my heatbed and a simple glass container with a lid.
https://www.dropbox.com/s/papnwqltsq...2019.31.15.jpg
https://www.dropbox.com/s/4metufsf1f...2019.31.30.jpg
https://www.dropbox.com/s/papnwqltsq...2019.31.15.jpg
-
06-15-2014, 02:43 AM #2
There's nothing worse than being beaten half to death by raggedy edged knuckledusters.
OME
-
06-15-2014, 06:08 AM #3
Hey it was just nice to print xD
Its not like i would beat anyone, Not even with a 3D printed one,
Btw who said it was actualy the size you would think it is? :P Could be a mini one ^^
Anyhow :P
I knew someone would say that, but from you Old man emu?!
haha :P
-
06-15-2014, 04:45 PM #4
Ha Ha! That was the product of a nearly deranged mind. I had just come back from wrestling with a print for a few hours and my mind was letting off built up pressure.
Actually, I have been smoothing some prints by lightly painting them with acetone and letting it evaporate off. Probably not very effective in terms of wastage of aetone.
OME
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help