How are you guys?I'm an enthusiast and I always thought a 3D printer was cool, I bought one hihiI bought it to make my dolls and interesting pieces like supports and organizers that I found on the internet.I have a question, I'm not in the engineering field and I don't have time to learn.Reading on the internet, I noticed that the best software is Ultimaker Cura, so I downloaded it from this link (https://github.com/Ultimaker/Cura/pu...28b3239a5a)and I installed it to match my printer model.I don't know how to configure it, so I looked online for several ready-made configs, and I found this one (https://github.com/Vanethrane/Cura-P...find/master)It suits me well, I only change it by clicking on bridges when I see that the piece has a lot of red.My question is, is there a better profile? Sometimes I think it takes too long to print.Can anybody help me ?(I would like to have 3 profiles, a perfect/slow finish piece, a normal/normal finish piece, a bad/fast finish piece)Thanks