Close



Results 1 to 2 of 2
  1. #1

    Issue with Ender 3 pro when printting

    HelloHello, I got my ender 3 pro + cr touch like a week ago and I decided to update the firmware for some reason. Every time I try to print now, it goes to the bottom left after heating up, then flies back to the middle and goes back to 0 temp. How do I fix this?geometry dash lite
    Last edited by angeloghee; 05-21-2024 at 01:57 AM.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,167
    Add Roberts_Clif on Thingiverse
    If you flashed your firmware then in order to figure out what went wrong you will need to post at least the configuration.h and configuration_Adj.h files.

    This way we can see what is going on, then we can suggest a course of action.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •