Results 1 to 7 of 7
Thread: Starts well, ends terribly
-
02-27-2024, 04:52 PM #1
- Join Date
- May 2021
- Posts
- 8
Starts well, ends terribly
Printing cable clips, looks good in the beginning but as it gets higher it goes from bad to worse, whats going on? Thanks.
-
02-28-2024, 02:18 AM #2
- Join Date
- May 2020
- Posts
- 685
Just a suggestion.........
Check your extruder 'e' steps and try ORCA slicer, it has some built in calibration files that you just have to print.
-
02-28-2024, 02:26 AM #3
- Join Date
- May 2021
- Posts
- 8
Unfortunately my printer isnt listed in Orca.
Last edited by Albertoinbox; 02-28-2024 at 02:40 AM.
-
02-28-2024, 02:49 AM #4
- Join Date
- May 2020
- Posts
- 685
Which printer are you using?
-
02-28-2024, 03:22 AM #5
- Join Date
- May 2021
- Posts
- 8
Flashforge Guider 2
-
02-28-2024, 05:19 AM #6
- Join Date
- May 2020
- Posts
- 685
Perhaps manually transfer the settings from your current slicer into ORCA slicer as a start. bit tedious, but one way to make your own slicer profile.
Also look on YouTube for over and under extrusion problem videos
-
02-28-2024, 05:11 PM #7
- Join Date
- May 2021
- Posts
- 8
Thanks for the help
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help