Results 1 to 2 of 2
Thread: What is going on here?
Threaded View
-
01-19-2024, 10:38 AM #2
- Join Date
- Jan 2024
- Posts
- 2
Solved
Going to answer my own question here.My assumption that a snug eccentric nut was a good thing was wrong. One of the y-axis rail eccentric nuts was a bit too tight so easing off on it fixed the issue.I would suggest that when you are adjusting these, run the axis at 250mm/s (15000mm/min) back and forth to make sure it is running smooth.You can use the G-Code command: G0 F15000 [axis][location] ex. G0 F15000 Y200
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help