Results 1 to 3 of 3
Threaded View
-
09-18-2023, 06:54 AM #2
- Join Date
- Nov 2022
- Posts
- 18
What slicer are you printing from; FlashPrint5?
Does the feeder click when attempting to print (trying to push filament that won't move)?
Many things could cause that problem, from a loose wire connection, erroneous slicer setting, bad stl file, etc.
Things you can try:
Unplug the printer for a minute and plug it back in; reset the electronics.
Check your nozzle temp when printing and make sure it's not shutting off.
Try printing a known good .stl file to make sure it's not just a bad file you're trying to print.
Good luck, hope you get it working.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion