Close



Results 1 to 3 of 3
  1. #1

    Filament not coming out when printing

    Hello!
    I have a Flash Forge Adventurer 3 Lite printer. It appears that there is no filament jam because when I load it, the filament comes out properly. The problem is when I try to print. The printer parts move as expected but the filament won´t come out from the nozzle. I would appreciate any help. Thanks a lot in advance.

  2. #2
    What slicer are you printing from; FlashPrint5?

    Does the feeder click when attempting to print (trying to push filament that won't move)?

    Many things could cause that problem, from a loose wire connection, erroneous slicer setting, bad stl file, etc.

    Things you can try:

    Unplug the printer for a minute and plug it back in; reset the electronics.

    Check your nozzle temp when printing and make sure it's not shutting off.

    Try printing a known good .stl file to make sure it's not just a bad file you're trying to print.

    Good luck, hope you get it working.

  3. #3
    Quote Originally Posted by nozzle View Post
    what slicer are you printing from; flashprint5?

    Does the feeder click when attempting to print (trying to push filament that won't move)?

    Many things could cause that problem, from a loose wire connection, erroneous slicer setting, bad stl file, etc.

    Things you can try:

    Unplug the printer for a minute and plug it back in; reset the electronics.

    Check your nozzle temp when printing and make sure it's not shutting off.

    Try printing a known good .stl file to make sure it's not just a bad file you're trying to print.

    Good luck, hope you get it working.

    thank you very much. I´m using flashprint. I´ll try your tips.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •