Results 1 to 5 of 5
Thread: Problem with 3D project
Threaded View
-
03-17-2023, 03:53 AM #4
- Join Date
- Jun 2014
- Posts
- 886
TGFT, (may I call you TGFT?), without a clear analysis of the failure mode, one can only make a guess. The photos of the character exhibit specular reflections. The bright dots on the surface can confuse many scanners. One possible solution is to use a powder spray to encompass the entire model in a matte finish white which will remove this problem. There are (expensive) sprays specifically made for this, but there are also ordinary chalk sprays that work in a similar manner at a lower cost. In these products, water is used to remove the spray after the scan is complete.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help