Results 1 to 1 of 1
-
03-14-2023, 05:34 PM #1
- Join Date
- Mar 2023
- Posts
- 3
high temp thermistor/ thermocouple advice
Hey to all, I am new here and still fairly new to 3d printer although I have owned a delta printer since years.
Basically I bought one way to early in time and a crappy one too (geeetech g2s pro delta).
So i am rebuilding and upgrading it..
but i got stuck on the choice of thermistor / thermocouple.
As board I will be using a mks Robin Nano V3.1 which probably uses the standard 4.7k pull-up resistor.
Anyway, I am looking (for future use) to upgrade so it is high temp capable, so ofcourse this needs to included the thermocouple.
I have purchased (blindly) a K Type Thermokoppel (1M Hoge Temperatuur Sensor 0-600 degrees), but i am not sure if i can use that without a module (like MAX6675 type) on this board.
Also I wouldn't know how to use a module like this on my board if i would need to use it and to use a pt1000 i would need to upgrade the onboard resistor which i can't and again for a pt100 i'd need a board again.
So any advice on what to use,and more importantly how to connect this (properly) any thoughts on the topic would be very much appreciated.
Kind greats Matthieu
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help