Results 1 to 2 of 2
Thread: New to 3D Printing
-
01-04-2023, 06:25 AM #1
- Join Date
- Jan 2023
- Posts
- 3
New to 3D Printing
Hi, I am very new to 3d printing as the 3d printer I have is a gift from a friend.
Initially, I did some tinkering and manage to get some prints out (benchy and calicat) but still need to fix the settings and all.
I decided to install the SN04-N sensor that came with the box and after updating the firmware this is what I get:
20230104_100736.jpg
I do not know what I may have done wrong but I followed the youtube video I found on how to install this.
To give reference, the sensor is connected to the Red which is Z-, yellow is Y- for the bed, blue is X- for the extruder
20230104_184626.jpgrn_image_picker_lib_temp_d3b27233-8aa7-441e-b77b-d20c567ac9f7.jpg
Any recommendations on how I can fix this. Also, I disconnected the other endstop for Z- as the sensor uses that. Thinking of still using the endstop sensor for Z+ stop instead also.
Thanks in advance.
-
01-04-2023, 06:26 AM #2
- Join Date
- Jan 2023
- Posts
- 3
I forgot to mention, I used Jim Brown's firmware for the upgrade.
New Here, don't print but need a...
06-20-2024, 12:18 PM in General 3D Printing Discussion