Results 1 to 3 of 3
Thread: No top and bottom layers?
Threaded View
-
11-30-2022, 03:32 PM #2
- Join Date
- Jun 2014
- Posts
- 885
The print you've shown is created with a hexagonal infill of relatively low percentage and the slicer has the settings for top and bottom layers set to zero. If you are unable to duplicate this, provide the slicer you use, to better advise location of those settings.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help