Close



Results 1 to 2 of 2

Threaded View

  1. #1

    Uneven first layer thickness between holes - not a levelling issue

    I've been scratching my head about this one for hours.As you can see in the picture. the first layer thickness is fairly consistent but when you look at the spots the are filled out later, they seem to be "thinner". I can see more of the bed through them.Pretty sure this is not a levelling issue since it looks very correlated to the are filled later. and everywhere just around it is fine.Does this have to do with the fact that there is a retraction before it gets to that island ?Any suggestions on the underlying cause?Printer : Ender 3 V2Slicer : Cura 5.11Layer thickness : 0.2Fist layer thickness : 0.24Speed: 60mm/s
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •