Results 1 to 2 of 2
Thread: Tree support issue
Threaded View
-
10-24-2022, 12:36 AM #2
- Join Date
- May 2020
- Posts
- 625
I can't help with the support issue, however the line of filament is a purge line to make sure filament is flowing.
It is set with the start and end G-Code in the printer settings.
You can cut and paste the G-codes from your Ender 3 into your new printer start and end codes to replace what is in there.
Just copy and save any G-codes from the Cobra Max just in case.
Just as an aside, I have found the Prusa slicer gives me good results and is easier to use than Cura for me.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help