Results 1 to 2 of 2
-
10-08-2022, 03:45 PM #1
- Join Date
- Oct 2022
- Posts
- 2
CR Touch Bed Leveling System Help with Ender 3 Pro
I have an Ender 3 pro and I just installed the CR touch bed leveling system. When I set the z offset and then start a print, it doesn't work, the tip is either too close or too far from the bed. It isn't working at all how it is supposed to. Is it the firmware? What am I missing? Any suggestions are greatly appreciated.
-
10-09-2022, 06:51 PM #2
- Join Date
- Oct 2022
- Posts
- 2
Lots of views on this but no replies, just wondering if anyone out there has experience with this bed leveling system and could help.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion