Results 1 to 7 of 7
Thread: issues after filament change
Threaded View
-
10-05-2022, 05:23 AM #3
- Join Date
- Oct 2022
- Posts
- 4
OK, So I added another M code right after the filament change to heat the filament to its maximum range which is 220 before resuming the print. I started the print at 200, which is the minimum. I also slowed the print speed down from 50 to 30 thinking this might help. I still have the same issue though.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion