Results 1 to 2 of 2
Thread: Prusa Slicer and an MP10
-
09-08-2022, 11:23 AM #1
- Join Date
- Apr 2018
- Posts
- 11
Prusa Slicer and an MP10
I’ve been 3D printing with an Anet A8 I built and a Monoprice Maker Select V2 since early 2018 so I’m not completely new to this but I’m having an issue I can’t figure out and I’m sure it has to be a simple settings issue.
I just bought a Monoprice MP10 and when I use Prusa Slicer which is what I’ve always used with my two other printers it’s trying to print about 1/16” above the bed and no matter how much I adjust the Z offset on the printer itself it does nothing.
Using Cura it works just fine, I’m just not a big fan of Cura. It’s clunky and slow even on my fairly powerful desktop, let alone with the MacBook I use for my slicing software. I’ve been through the settings between the two over and over and can’t seem to find what’s locking me out of adjusting the Z axis.
Thanks in advance for any advice.Last edited by Kyle M.; 09-08-2022 at 04:50 PM.
-
09-08-2022, 09:50 PM #2
- Join Date
- Apr 2018
- Posts
- 11
Well I never figured out what setting/s it was but I fixed it. I deleted all of my Prusa configurations and started from scratch, so far so good.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help