Results 1 to 3 of 3
Thread: Ugly walls on my prints
Threaded View
-
08-25-2022, 01:26 AM #3
- Join Date
- Aug 2022
- Posts
- 2
Hi,
The creality slicer had preset for Ender 3 as well..
But non the less i finally figured out what the problem was. For whatever reason 100% filament flow is not enough. (Probably bad configuration in firmware) Bumping the flow to 135% fixed all of my issues.
Thank you anyways though.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion