Results 1 to 6 of 6
Thread: Prusa slicer start G-code
Threaded View
-
08-24-2022, 09:27 AM #4
- Join Date
- May 2020
- Posts
- 634
Thanks, you've pointed me in the right direction.
I removed the curly brackets completely and just put a number in.
Just done a very small trial print and it worked okay, the only part not printed is the purge line from where it stops printing it on the LH side to the actul skirt.
It did seem to print quicker than the Qidi sliced print, too warm to remove to check the finish yet.
Printer will print perfect...
Today, 09:40 AM in Tips, Tricks and Tech Help