Looks good. To remove a chip:1) Put some flux on the pins and then melt lots of solder across all the pins on both sides. The more the better. Try to make a little solder bubble that covers all the pins. But be quick and don't linger with the solder iron. Using the flux and having a hot clean iron tip make this much easier.2) Slide an xacto knife blade or similar under one end of the chip and apply very very light upward prying force while briefly touching the solder iron to the solder bubble on one side. You should feel the pins on that side break mostly free but they might still be in the solder bubble. That's ok. 3) Shift the iron to the other side and repeat.4) If the chip hasn't popped off yet, shift back to side 1. Heat and pry a little more. 5) Repeat till the chip pops off. Never pry hard or heat for long or you risk yanking the traces off the board, which sucks.