Results 1 to 6 of 6
Thread: I have some bsic questions
Threaded View
-
08-07-2022, 01:12 AM #6
- Join Date
- May 2020
- Posts
- 626
Perhaps if you go down the keel and bulkheads route it might be better to make the bulkheads undersize to allow to plank the surface for a mould plug, rather than fill in between the bulkheads with foam or balsa.
I think planking sanded smooth would give you a better uninterupted surface than filling between the bulkheads and then sanding smooth.
However, either way could see you with a lot of work to get the surface you're after for moulding a display model and it might be better to just carve from solid.
Anyway I wish you luck and hope you'll post the results here.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)