Results 1 to 1 of 1
-
07-23-2022, 09:35 AM #1
- Join Date
- Jun 2022
- Posts
- 1
Anet ET4 Pro X-Y shift when driving clock- and than anti-clockwise
Hello, I have a brand new Anet ET4 Pro. The problem is, that it does not print in two directions (clockwise/anticlockwise movement) the same way so if I want to print an circle and the nozzle drives clockwise it´s printing an circle but when the nozzle than drives back to make the inner wall (anticlockwise) it drives a different direction so it is always that than the back left and front right side of the circle has a gap between the two lines ->see attached pic.
I did this with the stock firmware and also with the marlin firmware. I tried also different slicer/cura versions and also different settings. Also adjusted the steps/mm and extrusion at my marlin firmware with no improvements.The crazy part is that I don´t know why the circle is ok when the nozzle is driving only in one direction and not when it´s driving in the one and then in the other (clockwise/anticlockwise). So I also thought it could be a mechanical problem and tighten all screws and also checked the belts if they are to tight or not.
Hope anyone can help me with this.
unnamed.jpg
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help