Results 1 to 4 of 4
-
05-25-2014, 05:30 AM #1
- Join Date
- May 2014
- Posts
- 6
Sigma 3D Printer and My Quest to Build It
Hi,
I am a newbie who has always been interested in 3D printers but was reluctant to buy one, intimidated by the required technical knowledge. However, I have decided to bite the bullet and purchased a 3D printer kit recently from a local manufacturer based in Turkey. It is the second unit they have produced, so they are just getting in the businness. This is and will be a complete adventure for me as I have never performed any DIY type of work previously. I'll try to document everything related to the kit and its assembly. I'll also try to introduce basic concepts which, I think and hope, will be useful for beginners like me.
Here's the link: http://www.3dprinterblog.org
I am open to suggestions and advice.
Thanks....
-
05-31-2014, 12:40 PM #2
- Join Date
- May 2014
- Posts
- 6
Hi,
I have added a blog entry about the motors used in the kit and also motors in general.
Here's the link: http://www.3dprinterblog.org/2014/05...ts-motors.html
-
06-17-2014, 01:48 PM #3
- Join Date
- May 2014
- Posts
- 6
Hi,
I have added a new blog post on how to mount the Y motor and I also talk about the timing belts.
Here's the link: http://www.3dprinterblog.org/2014/06...xis-motor.html
-
07-06-2014, 05:27 AM #4
- Join Date
- May 2014
- Posts
- 6
Hi. I have added a new entry to the blog. Here's the link: http://www.3dprinterblog.org/2014/07...ators-and.html
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion