Results 1 to 2 of 2
Thread: Struggling with dots on prints
-
06-16-2022, 04:03 AM #1
- Join Date
- Jun 2022
- Posts
- 2
Struggling with dots on prints
Hi All, I am struggling with getting dots on my prints. I use Ultimaker Cura as my slicing software and most settings are the standard defaults. My prints has dots on them at the back. I am attaching a pic of a yorkie I printed. I decided to print the infamous xyz cube, and yes they are very obvious in this print, attached is the view of the front of the cube as well as the back. I am using a ender 3 v2 printer. Any suggestions would be greatly appreciated. What have I done: Upgraded the springs to remove bit of movement that was on the build plate. Spent hours on bed levelling.Any other suggestions. Thanks in advanceClydie
-
06-17-2022, 03:40 AM #2
- Join Date
- Jun 2022
- Posts
- 2
Misunderstanding
Thanks, maybe I was not clear, but it is more like blobs and pimples than dots. Look at the attached pictures.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion