Results 1 to 5 of 5
Thread: First layer not sticking
Threaded View
-
06-16-2022, 12:25 AM #4
- Join Date
- May 2020
- Posts
- 626
Look in your slicer settings for where you can hopefully change the global 'Z' axis setting.
I think you will have to put a negative input there, just try a small amount each time until you are happy, can only suggest perhaps minus 0.05 to start with.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion