Results 1 to 6 of 6
Thread: Technical Information Resources
Threaded View
-
05-05-2022, 12:56 PM #5
- Join Date
- May 2020
- Posts
- 626
I am not as knowledgeable about Cura or any slcicer as I would like to be so I can only offer any information that occurrs to me.
At a guess it will be a setting somewhere in the numerous speed settings, could even be the travel speed, typically in my slicer it's set at 100mm/sec.
I think it is really a matter of experimenting with various settings, slower is very often better than risking a ruined print.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion