Results 1 to 4 of 4
-
05-27-2014, 05:50 PM #1
- Join Date
- Oct 2013
- Posts
- 259
Bar Mixvah, The 3D Printed Robotic Bartender
Check out this new 3D Printed bartending robot called the Bar Mixvah. A man named Yu Jiang designed and built the robot, which cost him a total of $180 in parts, mostly for the power supply, and pumps. It took him approximately 18 hours to print out all the parts. The following are the parts he needed to construct the entire machine. The full instructions as well as the 3D models can be found at Jiang's website here: http://yujiangtham.com/2014/05/25/bu...-robot-part-1/
- 5x 12V DC peristaltic pumps
- 11x 5/16″ steel square 12″ rods
- Clear tubing
- Arduino Nano
- 5x TIP120 w/ Diodes
- 400-point breadboard and jumper wire
- 5x 2.2kOhm resistor
- 4x #6-32 2″ machine screws
- 12V power supply rated at (or greater than) 1.5A - or you can use an old laptop power supply (as long as it’s 12V DC).
- 5.5mm x 2.1mm coaxial power connector (female) - or if you’re using a laptop power supply, 5.5mm x 2.5mm
- Male pin connectors
- Female housing for the male pin connectors
Watch the video below to see the 3D printed bar tender in action. Are any of you guys going to try making this?
Last edited by RedSox2013; 05-27-2014 at 05:55 PM.
-
05-27-2014, 11:14 PM #2
-
05-28-2014, 02:40 PM #3
- Join Date
- May 2014
- Location
- Houston
- Posts
- 53
Yes! I need me that!
-
05-28-2014, 03:30 PM #4
- Join Date
- Apr 2014
- Location
- UK
- Posts
- 64
Good for consistency every time you want a specific drink, it will always taste the same.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help