Results 1 to 3 of 3
Thread: Help with print settings for ASA
-
04-21-2022, 07:05 AM #1
- Join Date
- Apr 2022
- Posts
- 1
Help with print settings for ASA
Hello, I am trying to print with ASA for the first time and having problems getting the desired result. I'm using
- Dynamism ASA 2.85mm
- Ultimaker 3 (I don't have any type of enclosure)
- Latest version of Cura Using the CURA preconfigured "FINE" settings
- With the following changes
- Print Temp - 250f
- Bed Temp - 80f
- Print Speed - 40mm/s
- Cooling - Off
- Infill - 100%
- Also using Magigoo original
- Here is what I am trying to printDesired Result.jpg
- Print is not flat, it's warped upwards.IMG_4901.jpg
- The structure at the back of the print is misalignedIMG_4902.jpg
- Please help suggest what I should change in my settings.
Last edited by dudical26; 04-21-2022 at 07:15 AM.
-
06-29-2022, 08:30 AM #2
- Join Date
- May 2020
- Posts
- 627
Try bed temp around 95C.
Drop your speed to 30-35. Slower is better.
Preheat chamber with bed for a good 30 mins before starting print.
On no account open doors until print has finished and everything is back to ambient temperature.
Don't know about infil but I've never gone above 25%
-
07-10-2022, 11:37 PM #3
- Join Date
- Jul 2022
- Posts
- 1
That's the good answer. Thank you very much super moderater.
Stickman Boost
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion