Results 1 to 5 of 5
Thread: Layer adhesion problem
Threaded View
-
04-19-2022, 11:52 PM #2
- Join Date
- May 2020
- Posts
- 626
Suggest you print a single layer bed leveling test, plenty of these on Thingiverse.
You might find that although you have leveled the bed there could be places the bed is still either too high or too low due to distortion.
If this shows variation in different places you can always try to place objects where you'll get the best results.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion