Results 1 to 10 of 11
Threaded View
-
04-03-2022, 06:28 PM #6
Inspected your G-Code Frog.gcode to find in the code what could cause your problem.
I printed Your G-code without any modifications other that what I call draft mode (full Speed) below is the results.
Frog.jpg
You can see under the frogs chin that there should be build plate supports.
An other rings in the texture and obliviously I printed it way too fast.Last edited by Roberts_Clif; 04-03-2022 at 06:35 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion