Quote Originally Posted by Roberts_Clif View Post
Partially Was looking for filament temp, print speed, filament type, ectWanted to get a ideal of basic settings.It almost seem impossible to print a perfect flat layer then print a cylinder with a rough inside bottom layer.Is it possible to see the File to look at for only that model.
I agree that it just doesn’t make sense but it has now happened twice. Both attempts with the stirling engine gave those poor results while everything else is good. Those values I gave above were the only settings that I addressed in the model that would have differed from the printer default settings. I’m printing a fairly large job now but will try to recreate the settings and print the model a third time. If I get the same results I’d be more than happy to share the file to see if something can be figured out.Harry