Results 1 to 4 of 4
Thread: printing error
Threaded View
-
03-06-2022, 04:09 PM #2
It appears your nozzle is too high an needs to be lowered.
I use Z-Offset to lower the nozzle to get about .2mm above the bed. currently my Z-Offset is set at -0.50
I have had this setting from 1mm to -1mm to allow the nozzle to be in the print areaLast edited by Roberts_Clif; 03-06-2022 at 04:14 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion