Results 1 to 10 of 12
Thread: Show your most impressive print
-
05-22-2014, 06:58 AM #1
- Join Date
- Apr 2014
- Location
- Greece
- Posts
- 3
-
05-22-2014, 07:06 AM #2
- Join Date
- May 2014
- Location
- Belgium
- Posts
- 15
Show your most impressive print
We all love 3D-printing because we can see ideas come to life. Therefore I made this thread so you can show off the prints you are most proud of and why. Additional info like print-time, issues you had etc.. are always nice.
I'll start off with mine:
This Eiffel-tower from thingiverse: http://www.thingiverse.com/thing:254133
I printed this thing after not having that much experience with my printer. It really was a challenge, took me over 2 weeks to complete and several failed parts. I learned so much about all the different settings in Cura while attempting to get the small detailed parts in a decent quality.
1510982_10202852992957427_5815045185779230447_n.jpg10013515_10202852993157432_5140100099797696810_n.jpg
used printer: Velleman K8200 aka 3drag
Issues I had: This print had allot of small separated parts which makes the printer retract ALLOT. This resulted in a completed grinded of piece of filament which resulted in stop of filament flow. Then I had to pull out the filament, cut the bad part away and continue the print. I had to test by trial-and-error what the best retraction setting was without getting very bad quality.
Print-timed: I stopped counting after 30 hours of printed parts.. Took me over 2 weeks to test, print, assemble.
Resolution: 0,20mmLast edited by KLucky_13; 05-23-2014 at 01:58 AM.
-
05-22-2014, 09:08 AM #3
- Join Date
- May 2014
- Location
- Belgium
- Posts
- 15
Here you have the link:
http://www.thingiverse.com/thing:254133
If you want to scale down the model: check the remix section, I made part D2 without the fine railings, so it's easier to print when it's scaled down
-
05-23-2014, 01:36 AM #4
- Join Date
- Apr 2014
- Location
- Greece
- Posts
- 3
-
05-23-2014, 01:43 AM #5
- Join Date
- Mar 2014
- Location
- Vienna
- Posts
- 47
Looks great!
Maybe you can tell us what printer you´ve used here.
-
05-23-2014, 01:57 AM #6
I suspect it is the K8200 mentioned here: http://3dprintboard.com/showthread.p...ll=1#post16214
-
05-23-2014, 01:59 AM #7
- Join Date
- May 2014
- Location
- Belgium
- Posts
- 15
You are right, I've added it to the post, it's a velleman :-)
-
05-23-2014, 07:46 AM #8
Only need a little modification : Self-alignement hole!
-
05-23-2014, 11:46 AM #9
-
05-25-2014, 09:44 PM #10
I got my favourite print - It's a thing I created; named him CHEG! - Print quality is nothing special (Poor ABS actually) but cool.
The other was a gift I made for my wife... White ABS and texters.
photo 1.jpgphoto 2.jpgphoto 3.jpgphoto 4.jpg
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help