Results 1 to 10 of 44
Threaded View
-
02-07-2022, 01:17 PM #22
- Join Date
- Jan 2020
- Location
- Bel Air Md
- Posts
- 181
These two feel Metalic like crimped wires. Pulled apart have same resistance of 19.5 ohms. I can imagine that close to heater they heat up a bit and move closer? I have some tapcan tape Im going to put a piece between those two. And in answering your question did this start when thermistor was changed? NO, I changes thermistor thinking it was the culprit. It started lil after changing 235 x 235 carriage bed to 300 x 300 but still used smaller bed heater (235 x 235) for the time being as didn't yet haf full size heat bed
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion