Results 1 to 1 of 1
-
12-13-2021, 10:50 AM #1
- Join Date
- Dec 2021
- Posts
- 1
Print Settings for onyx filament on a QIDI X-plus.
I have been printing a part with the onyx on a markforge printer and it prints good enough. that printer is not working at the moment. I have a QIDI x-pro that i am trying to print with the onyx filament that is nylon with carbon fiber in it. but i am getting a weird pattern on the side of the part that looks like lines diagonal on the side. I think the printer is able to print this i think it is a setting or a few but not sure where to begin looking. I am not sure the settings for the markforge printer they don't show you them but they are preset and you can't change them. I am using the QIDI slicer I am printing at 275 with a .4 hardened nozzle.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion