Results 1 to 6 of 6
Thread: Filament Jamming in Hotend. Why?
Threaded View
-
11-29-2021, 02:54 PM #5
also the blob is a clear indication that the bowden tube needs pushing down further, you should never have any gaps. That will cause a clog.
And yeah, smoke at 225 is definitely not anything that can happen at 225.
You've got to go a lot higher to get smoke from pla, I mean a LOT higher.
but a short circuit or sparking wire or conection would cause smoke.
That's most likely your culprint. Either a dodgy thermistor or heater cartridge wire or connection.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help