Results 1 to 10 of 13
Threaded View
-
11-23-2021, 10:47 AM #13
- Join Date
- Jan 2020
- Location
- Bel Air Md
- Posts
- 181
I believe my issues were from a sloppy 'X" axis (one where hot end goes back and forth) was increased to 390mm I could see left side start to move before right did. Im in process installing a dual Z drive
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion