So I have done a couple of things to clean it, I first heated the bed to 50c and then used rubbing alcohol and a paper towel to wipe it off, after that I used some warm water and another paper towel. I have been playing around with the temps, originally it was 200 nozzle and 60 bed, then I went up to 210 nozzle and 70 bed. I actually got some direction elsewhere that seems to have started helping. I gave the bed another clean and changed the following settings: initial layer height went from 0.10 to 0.24, layer height from 0.10 to 0.14, bed temp from 210 to 196, nozzle temp from 70 to 55. With these settings it seems like the printing are sticking so fingers crossed I found the proper balance.