Results 1 to 5 of 5
Threaded View
-
05-20-2014, 10:06 AM #2
That is not too good, I have levelled my bed a zillion times now and am yet to lose any threading on the screws, and I rarely push down anymore because it offsets the rest of the plate if you press on a corner too hard.
The sheet on the aluminium is kapton tape, it's cheap to replace, about 3 meters (which is the right width) for about $15-20. Just peel it off like sticky tape, but dont do that until you have your new tape.
you can also buy Blue plumbers tape, I don't like it myself because you don't get the nice shiny finish on the botton of your prints with that, either kapton tape or a glass plate over the heatbed - but you need tempered glass or it will crack.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion