Results 1 to 5 of 5
Thread: Problem with bottom layer.
Threaded View
-
09-05-2021, 01:45 PM #4
- Join Date
- Sep 2021
- Posts
- 9
Do I adjust the Z gap with the calibration?
So it turns out the main problem was i wasn't using supports but I tried with supports and it still could use some improvement. I'm using an Ender 3. Where do I check the extrusion width? My initial layer speed is 20mms.
No raft being used.
My support settings are Tree, touching build plate, support angle 45.0, pattern - zig zag, support density 0,
Here's a similar file that I printed recently, better but still could use some improvement.small sized 3d print pic.jpg
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion