Results 1 to 5 of 5
Thread: Problem with bottom layer.
Threaded View
-
09-05-2021, 01:21 PM #3
yeah that's definitely a problem :-)
I can see a number of issues.
1) z-gap is too large, you need to calibrate with thinner paper or adjust your z-axis offset to move the printer head nearer the printbed..
2) overextrusion. in a big way :-) Check the percentage extrusion width of your first layer. It should be 100%
3) first layer print speed - it's probably too high. first layers should be printed at around 10-20mms for best adhesion.
4) check to see if you are printing a raft. If so, switch it off. for pla you should never need one.
But yeah, give us some infomation to work with :-)
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)